Tiny Keychain Micro SD Card Holder (for 2 cards)

Hello,

this is a holder for 2 micro SD cards that can be attached to a keychain.

The holder snaps into place easily and is then securely closed. The tab on the side has a snall notch to make it easier to open the holder again.

I tried to make it as small as possible to reduce the likelihood of it getting tangled on a keyring or in your pockets.
The hole for the keychain has a diameter of 4 mm.

I recommend bending the joint manually after printing, so that it closes the holder properly later.

One important last thing:

I have a good gut feeling about the holder, but I have not yet been able to test it for a long time. So please don't use it to transport sd cards that you can't afford to lose!!! Thanks

Please leave a comment or shoot me a message if you like the holder or have any ideas how it could or should be improved. Thank you! :-)

If it does not work for you please leave a comment or shoot me a message instead of just posting a 1 star review, I'm sure there is no problem that can't be solved.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Supports:

No

Infill: 

40% Gyroid

Filament:

AmazonBasics PLA light Grey 
 

Notes: 

No supports needed.
I sliced it with 0.12 mm layer height in Cura.

Printing time is approx. 20 minutes

Category: Organization