Workmate feet big and small

Large lower foot and smaller triangular foot for Black and Decker Workmate WM5XX. These fit well and have been on mine for some time now. I printed these in Rigid Ink TPU with the speed slowed to about 20mm/sec. I still get a bit of stringing on the inside but the outside finish is good and the strings can be just pulled or cut off.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Mk2

No

Supports:

No

.2mm

Infill:

100%

Notes:

Works best with the speed slowed down to about half normal as this reduces the stringing. I use either 100% fill or many perimeters to get a solid bottom casing as they get a lot of wear. Print with the bottom of the foot to the bed and you will not need supports