Latching Under Desk Slide Out Mount For A Lenovo M700 (or M93p) Tiny PC (With STEP File)

UPDATE 8-20-2021: I updated the latch after using the same design on a Pi4 holder (posted here: https://www.thingiverse.com/thing:4936218). I have not tested this model, but I did test the latch using the Pi4 holder and it worked there. I'm not planning to print this however, since I already have the non-latching version of this thing, which works OK for me. If you do print this please provide feedback. I suggested calibrating flow prior to printing this since there are dovetails and close fitting parts.

This is an untested work in progress (though at this time I don't plan to work on it unless there is a problem). The design is not printed, not tested and so if you do print it, it will be at your own risk, etc, but please provide some feedback if you do.  Also please do not rely on the latch to hold the weight of the PC, it is more of a catch to keep it from easily sliding out.  If you need to to be held in place with more security, use the screw on the back to hold it. 

The only difference between this and the original design it was remixed from is that this model has a latch to secure the PC in the mount. The latch is held in with a M3x12mm Cap head screw, and an M3 washer, and an M3 locknut. There is also a spring loaded detent provided by a spring from a clicky ball point pen.

The parts are not oriented for printing, and the STEP file is provided for easy remixing. If you do happen to print this, please post a make and some feedback. If there is a problem that I have enough info to resolve in the model I will try to fix it. At this time however I do not have time to print this. and this is not something I urgently need since I have already printed the older design (so it may be a long time before I can test it).

Print Settings

Printer Brand:

Creality

Printer: 

CR10S PRO

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

20%

Filament:
ANY PETG and PLA ANY

Category: Office