Revel Bedtrack Smoothies

Revel Bedtrack Smoothies

Here's a demo:
https://youtu.be/f374Q\_momYc

Make your Revel's garage safer with these bed smoothies. They were designed for use with the GLSS, but also work without the GLSS, so they don't catch and scratch things in your Revel's garage.

I'm making the design available for free* , so you can print it at home:
https://www.thingiverse.com/thing:4762681

If you don't have a 3D printer, you can buy a pair here:
https://www.tindie.com/products/thrasher/revel-bedtrack-smoothies/

What is it?

This part provides a smooth transition on the sharp edges of a Revel's bed track, so you don't cut yourself. The stock Revel setup has a sharp edge than can cut your finger, a GLSS, or anything that bumps up against it while you're out living the #vanlife. This part smoothes the those edges.

Why did you make it?

My kids and I were sitting our Revel, on the GLSS, and each cut our fingers on the track by accident. This part was invented to prevent that from happening.

What makes it special?

No tools are required for installation - it just slides onto the bed track for a snug fit. The color is intended to match the green trim found as an accent in other parts of the Revel and GLSS upholstery.

• Design is free for personal use, as outlined in the following license:
  https://creativecommons.org/licenses/by-nc-sa/3.0/

  Print Settings

Rafts:

No

Supports:

Yes

Resolution:

0.15

Infill:

15%

Filament:
Any PETG

Notes:

PETG provides better temperature stability in a vehicle than PLA. The inside of the van can get quite hot in the summer!

Orient the part on your build plate so that the "wall" of the van matches the build plate. Supports are only needed on the build plate.

How I Designed This

Designed using OpenSCAD and my trusty digital calipers.

Category: Automotive