Mew Mew Modular Desk Tidy System V2.0.2 ;-)

This Thing is a small revision of kozinc's Mew Mew desk tidy, in that I've added two 100 mm tall variants - one regular (same as all the others), and one double capacity (derived from two side-by-side singles).

I've also added little extra bits to the tops of the taller modules, so that whatever's being stored can't push the sides apart (prevents breaking the bottoms of the walls).

Print instructions

Licence: Creative Commons - Attribution Category: Containers Print Settings

Printer Brand: RepRap

Printer: Prusa i3

Rafts: No

Supports: No

Resolution: 0.2 mm

Infill: 100%/doesn't matter

Post-Printing

The taller containers tend to spread apart a bit at the top, so I recommend you print out some of little "reinforcing tabs" and to glue them onto the sides to hold the split together.