1st Gen 4runner Rear glass regulator piece

While installing a new regulator a small plastic piece associated with the rear glass regulator locking mechanism broke. A replacement part could not be sourced and being one piece would be impossible to install without destructive disassembly of the regulator. I designed a replacement part that can be installed with zero disassembly.  

Print Instructions:

I used 100% infill on filamentums CPE with a brim and supports set to ‘everywhere’

I think ASA or PC would work for this application but may require some tweaking to print well. 

The small screw used is a M2.5 x 0.45 mm Thread, 18 mm Long screw (McMaster-Carr # 91290A053)

No idea how long this part will last. Install at your own risk!