Slotcar 1/32 setup plate (Einrichtplatte)

This is a slotcar setup plate. One has a 1 mm, the other 1.2 mm offset. 1mm is the minimum clearance but 1.2 mm is needed for the Carrera track system.

It allows you to check if your slotcar is setup correctly.

Take care that your printer prints this plate square and level, otherwise it won't be of much help.

Remix of: https://www.thingiverse.com/thing:3929917

Source: https://www.tinkercad.com/things/jUinGXuKbr5

Update 19.01.2022

I updated the length of the slot gap, it is now much longer. I had issues with older Carrera evolution cars, which did not fit onto the plate because of the gap for the slot. The cars front wheel were to far at the front which made proper adjustments hard.