Parts Drawer for #1 Coin Envelopes

This is a parts drawer for holding small parts in #1 size coin envelopes. These envelopes are ideal for small things like resistors, transistors, diodes, seeds, etc.

An Openscad file is included so you can change the sizes. Changing the y dimension is necessary for printing on the mini.

There are two types of dividers. The thick divider fits into notches in the drawer to hold prevent the envelopes from falling over in a partially used drawer. The thin divider can be used the separate groups of envelopes as well.

The knob is attached using a 5mm M3 bolt.

The envelopes can be found here https://www.amazon.com/s?k=coin+envelopes+%231

Print instructions

I print this in PLA at 0.2mm. No need for support.