Tesla Model 3 Trunk Hook Extended

Remix of Motorpixiegimbals's threaded trunk hook (thing:3886904). Extended it by 2cm at the stem to better accommodate access to the hooks.

The bottom of the hooks have slightly problematic overhangs, so I enabled supports from build plate. --v2 Should not required supports

I also printed this using adaptive layer heights to improve layer adhesion on some of the object interface points, while also maintaining a reasonable print time.

I'd recommend PETG or better for anything that has to endure the heat that can build up in a car trunk, however I originally printed it with PLA+ (Inland) and used it throughout the summer without issue.

Changelog:
Jan 31, 2021
Uploaded a version 2 that has a maximum overhang of 60 degrees

Print instructions

Category: Automotive Summary

Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: Doesn't Matter

Supports: Yes

Resolution: 0.15 (Adaptive)

Infill: 40%

Notes:

Minimum 3 perimeters. Gyroid Infill.