Gaugemaster / MRC Prodigy Express Holsters

Summary

A set of holsters/brackets for use with the Gaugemaster (MRC) Prodigy Express DCC controller and base station. The controller holder will also work with the Prodigy Advanced controller.

Notes:
The controller holster is one part. It has countersunk screw holes and should be printed upright with no supports necessary. PLA+ is a good material for this, as it has some flex but is easy to print.

There are two versions; one is a wee bit smaller length ways to save on plastic. The base station holder comes in two parts to make printing easier and cut down on supports; use solvent weld (e.g. EMA Plastic Weld) to make a permanent joint.

While my Creator Pro managed to print it fine without supports in the cut outs, some printers/settings may not bridge so well, so you may need to add supports there.

These holsters are designed to be a snug fit. You can always increase the print scale percentage by 1% or so if they're a little tight on your set up/printer calibration.

Print instructions

Rafts:
Doesn't Matter

Supports:
Yes

Resolution:
0.2mm

Infill:
20% (or thereby)

Filament_brand:
Rigid Ink

Filament_material:
PLA+