Sanding Tool

Specifications:

The sanding tool requires 140x10mm sandpaper (cut from an arc), and you need to print one of each part.

Assembly Instructions:

1. Cut strips of sandpaper (140x10mm).
2. Insert the screw into the washer, then into the body; lightly screw on the nut.
3. Place each end of the sandpaper strip under the washer and around the body.
4. Hold the body with your fingers at the ends, gently press the body together to pre-tension the sandpaper, and tighten the nut.

Print Instructions: Print with a 0.4mm Nozzle and a layer height of 0.1-0.15mm, with 100% infill.