Snap Together Pot Rack

I designed this pot rack for my citadel paints but I haven't had a chance to print it yet. It will fit any other paint that would fit inside the 35mm diameter.

It is designed to be able to snap together with multiple copies of the same rack so as to extend the paint storage capacity. It also has built-in brush holding holes and a brush rest to keep them from falling out and rolling away.

Print instructions

I have not yet had a chance to print this design but the rendering is from Fusion 360.

Because of the size and shape of the pieces, I assume they will be more likely to warp. My reccomendation would be to print these with PETG on the MK3S Smooth sheet. All the filaments I have used seem to stick to the smooth sheet much better than the textured one and you're gonna need all the help you can get.

I think the largest assembly issue will be fit and finish with the tabs that lock into the sides. They may need some filing to fit nicely. (If you do print it let me know what measurements actually came out and what was needed and I can adjust accordingly)