Blanking plate for 120mm fan opening with seal

Blanking plate for 120mm fan opening on a computer case.

When managing air flow thru a computer case with an air filter then you likely want to blank off any unused 120mm fan openings.

This design contains a groove for a seal. A string of 1.75mm flexible filament will fit in.

The photo shows the blanking plate with seal (flex filament) inserted, laying on the inside of an Antec 300 computer case cover. The mesh in the background is intended for an additional 120mm fan for the grafics card will be fully covered by the blanking plate.

Print instructions

Category: Computer Print Settings

Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 10%

Filament: Any

Notes:
Additional string of flexible filament needed into the designed groove for sealing purposes.