Displate Wall Hanger (No Magnets)

This is a wallhanger to mount displates without magnets. It was designed with L sized displates in mind and I do not have an M sized displate to test it with.

Mounts to the wall using nails.

For each bracket you print you will need:

• 1x M4x10 Bolt
• 1x M4 Nut

The back bracket has a small 0.2mm layer in the screwhole to allow for printing without supports. This layer can be removed using a drill or even just a screwdriver after the print is done.

For mounting to the displate this relies on the folded over metal part on the back of the picture. Unfortunately this part is not a constant width. The spacing on this bracket is 14.7mm. In places where this fold is smaller the bracket will be a bit loose but should still fit.
Refer to the pictures for information on how to measure the width on your displate. Make sure to measure both edges as the fold isn't even constant for each side of the displate.