Tape dispenser roll

This is a replacement roll for a Tesa tape dispenser.
Tape roll inner diameter 26 mm / width 20 mm.
Nominal axis diameter 4 mm / length 26.2 mm.

The roll is assembled from 3 parts:

• 1 x roll,
• 2 x axis.

Axle parts are tight press fitted into the rolle.

I used PETG, but PLA should work (probably even better).
The inner diameter of the roll needed to be sanded slightly (removal of stringing) to get the axle in the right position.

Print settings:

• Layer height: 0.1 mm
• Perimeters: 3
• Supports: No