Zoom Phone Tripod

This collapsible tripod for your phone will handle all of your Zooming needs. It's easy to print, requires no supports and no additional parts.

Features:

-The three legs simply snap into sockets in the tripod base

-A screw ring is use to set the leg angle anywhere from collapsed to fully open

-The threaded post, when fully extended, can tilt forward and backwards by 30 degrees. When stowed in the base, it can be held in place by a clip on one of the legs.

-The screw knob at the top both clamps your phone in place between the jaws and also sets the friction level for tilting forward and backwards.

-Both jaws and the leg with the clip have tiny break-away support structures built-in. No need to turn on your slicer's supports. Just print as-in and break away.

Print one of each part except for print two of the plain legs. Assembly is straightforward - just use the photos as a guide.

Print Settings

Printer Brand:

MakerGear

Printer:

MakerGear M2

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.2mm

Infill:

20%

Filament: Inland PLA

Notes:

The leg with the clip and the jaws all have tiny built-in support structures with clearances that require slicing with exactly 0.2mm layer height. Just break away these small pieces after printing.