Enclosure Exhaust - (120mm fan, 4" dryer duct)

This exhaust system connects to common 4" dryer vent ducting. The fan grill/ air straightener part stops the fan from stirring the enclosure air.

The groove on the hose side part is to help keep the cable tie in place.

You can connect the vent hose directly to the fan side part if you want and not use the hose side part. I made the hose side connector so that I could easily remove the hose and/or attach it to my other printer.

Print instructions

Category: 3D Printer Parts Print Settings

Notes:

Straightener printed with 5 perimeters, 7% honeycomb infill and no top or bottom layers. This part prevents the fan from spinning the air in the enclosure and causing unwanted airflow.