toniebox holder

The original Toniebox charger fits into the holder. 
Only a raw outbreak of 10cm diameter has to be cutout of any mounting plate. The Holder can be fixed with four sunk screws (max. M3) or glued. 
A cable cutout is prefabed for nice cable manegment and the mains adapter fits through the inner cutout.
The charger fits a little bit tight in the holder but that is necessary, so the Tonie box don't lifts up the charger.

my praxsis checked printer settings:
Material: PLA
System preset: 0.20mm Quallity
Infill: Honeycomb 15%
Supports: Support on build plate only
Position: reduction screws on build plate (see photo)
Used Filament: 12.11m
Estimated print time: 2h51min
 

Happy Printing