Adjustment Bar for Taper Jig

Quick print to create an adjustable taper jig for a table saw.

Dimensions: 250mm x 29mm x 20mm ; slot is 9mm wide.

I did have issues with the print lifting on one end (I did not use any additional adhesive on bed) as it is a relatively long and thin print. However, this didn't affect in use.

Picture doesn't show washers on top but I recommend using them on bottom and top, as I started to damage print after a couple uses, not that it matters too much as I can quickly print another if needed.

Print Settings

Printer: 

i3 MK2S

Rafts:

Doesn't Matter

Supports: 

No

Resolution:

0.3mm

Infill: 

30% min.