PS4 Thumbstick Adaptors

This series of models hope to offer a variety of “swap-to-suite” PS4 thumbstick adaptors for adaptive play.

*Will likely be adding more/refining models. Open to suggestions, as each persons style of play may vary. 

- - - 

Pinwheel- Basic Grip

Anchor- Full, 6 Point, 5 Point

• Full- extended version of Pinwheel
• 6 Point- allowance for better access to D-pad/△, O, X, ▢
• 5 Point- more allowance for potential collision between joysticks

Rise- 18mm pad risen up 15mm

• Slice- trimmed one side for using two Rise adaptors at once

Arch- A rising arch that can place access to the thumbstick over the D-pad or △, O, X, ▢ buttons. Can also act as a handle to the thumb if positioned under the arch. [Needs support*]

• Hook- slightly hooked end for better pull
• Bulb- Reaches center of D-pad or △, O, X, ▢ (experimental inverse control) 
• Bulbv2- higher bulb version of ^
   

-  -  -  

Tested, and best printed, upside down in TPU. No supports necessary [unless noted*]

Filament: Polymaker's PolyFlex™ TPU95

Settings: (used PrusaSlicer's “Fillamentum Flexfill 98A” filament profile)